How fast do cyanobacteria blooms spread across a reservoir?

Wide view of a wind-rippled reservoir under a cloudy sky, with wooded shoreline in the distance.

Ask anyone who's chased a bloom around a reservoir and you'll get the same answer: it depends. There's no fixed number of miles per day a cyanobacteria bloom travels, because a bloom doesn't move the way a plume of dye in a tank does. It grows in place where conditions favor it, then gets pushed, concentrated, and broken apart by whatever the surface is doing that week.

That's the part that trips up a lot of monitoring plans. People want a growth rate they can plug into a schedule. What actually drives arrival at the intake is wind, not biology.

Wind does most of the work

Cyanobacteria, especially the colony-forming genera like Microcystis, regulate buoyancy with gas vesicles. On a calm morning a surface scum can sit nearly still, thickening where it is. Add a sustained wind out of one direction and that same scum sheets across the reservoir in hours, piling up against a downwind shoreline or stacking up near an intake structure that was clear the day before.

This is why two reservoirs with similar nutrient loads and similar bloom severity can behave completely differently. A long, narrow reservoir oriented along the prevailing wind direction lets a bloom travel its full fetch in a single windy afternoon. A reservoir with a lot of coves and points breaks that same wind field into smaller cells, so biomass gets trapped in pockets instead of making a clean run at the intake. Reservoir shape, fetch, and typical wind direction matter more for predicting where a bloom ends up than any growth-rate figure does.

Wind direction shifts also explain why a bloom that was nowhere near your intake on Monday can be sitting on top of it by Thursday. A front passes, the wind swings 90 degrees, and three days of accumulated biomass on the far shore gets driven straight across open water.

Growth rate still sets the stage

Growth rate answers a different question than wind does. It tells you how much biomass is building up somewhere in the reservoir under a given stretch of warm, calm, nutrient-rich conditions. Wind and currents tell you where that biomass ends up and how fast it gets there. A slow-growing bloom sitting in a cove for two weeks can still reach an intake in a single afternoon once the wind lines up right. A fast-growing bloom in a well-flushed arm of the reservoir might never make it that far if the hydraulics keep sweeping it back out.

Thermal stratification plays a supporting role too. Blooms concentrate at the surface or at a thermocline depending on the species and the time of day, and that affects how exposed they are to wind mixing versus how much they stay put below the surface where a shoreline observer wouldn't even see them building.

What this means for intake timing

For a source water protection officer, the practical upshot is that spatial monitoring matters as much as cell-count monitoring. Knowing a bloom exists somewhere in the reservoir tells you to start paying attention. Knowing where it is relative to your intake, and whether the forecast wind is going to push it that direction, tells you whether you have two days or two hours before it's your problem.

Algal Bloom Warning reads a daily-in-season satellite pass over your reservoir and flags bloom extent by its spectral signature as it forms, ahead of any drift toward the intake. The trend note tracks movement toward your draw point through the season, keyed to that specific location.

If you're staring at a wind forecast trying to guess whether tomorrow is an early-pull day, a daily extent flag during bloom season takes some of the guessing out of it.

Get started

← Back to the blog